CARE/TECHNICAL INSTALLATION INSTRUCTIONS
GLOVES/PADS/MITTS/HEADGEAR
 Do not use gear wet - this is abuse
Dry your gear out of your training bag in a well ventilated area away from direct sunlight
Use minimal baby powder to remove odours
Always use cotton inners or wraps to prevent excessive sweat ruining the stitching/materials in products, Sweat/Rot damage is not warrantable.
Ensure you have enough training gear to always use a dry set-especially in commercial use as over using a small insufficient amount of equipment is abuse and will void your warranty
Do not do push ups in boxing gloves unless they have "push up zone" printed on them
If the product is marked "washable" Hand wash separately in cold water, do not tumble dry, avoid washing more than 4 times per year.
BAGS
Its recommended you have your equipment installed by a qualified tradesman to check what you are fixing into is suitable for the considerable forces that are generated with use.
If you change the fittings or filling or adjust the strap/chain lengths you will void your warranty
Only use surgical spear gun rubber to fix the bag to the floor with the tie down feature
Avoid D ring wear on strap boxing bags by hanging them with 10mm rope instead of chain
Bags hung with twisted straps and chain is negligent assembly and may void warranty
Beating bags with weapons, striking with bare knuckles or shoes may puncture bags Puncture damage is not warrantable
Avoid dragging bags or pulling back on straps. This form of damage is not warrantable.
Avoid hanging bags near(within 1.5 meters) walls/mirrors and other gym equipment
Wipe bags down with disinfectant diluted in warm water once per week
Spray lubricate "D" rings and chains and places where moving metal parts touch once per week
WARNING: Inspect weekly for wear in strap rings, swivels, chains. Failure to do so can result in bag failing suddenly
FLOOR TO CEILING BALLS/SPEED BALLS
Do not over inflate-especially in hot conditions-inflate until ball feels firm(not hard) and your thumbs can push into material approx 1.5cm.
Changes in air temperature will require regular "topping up" of inflated bladders
Lick needle before inserting into bladders. Ensure you do not puncture bladders with needle.
Ensure floor to ceiling ball springers are not set too tight (should have min 30cm movement in any direction) as any less will damage the ball.
Ball straps and springers are perishable high wear and tear items and are excluded from warranty
Set height of floor to ceiling ball at approx chest height for best results.
The fitting of non PUNCH EQUIPMENT accessories will void your warranty
Note-all bags /speed balls and floor to ceiling balls require weekly inflation/adjustment & maintenance
Never strike speed balls/pads or bags with bare knuckles.
GEL PADDING WARNING: Gel will melt if left in direct sunlight, within heated cars or tumble dried.
This abuse is not warrantable |
